mr peas
06-10-2004, 06:02 AM
This is a pretty damn useful walkthrough, I hope it helps a lot of you!
How to reprogram FOB (Keyless entry remote)
Previously stated by SilviaS14KA24DE on Club240.com
For OEM stock keyless entry systems 95 < (and above)
1.Get in & lock the doors
2.Insert the key into the ignition 6 times within 15 seconds (taking the key out all the way, then back in).
3.Hazard lights should flash
4.Put key back into the ignition & turn to run position but do not start.
5.Hit the lock button on the remote
6.Hazards should flash.
7.Pull key out and open the drivers door and then close it
8.It should be set
HALT!!!
Remember to do number 7! most people think it's programmed after they pull the key out. you have to unlock the doors, open the drivers door, then close it to be programmed correctly.
How to reprogram FOB (Keyless entry remote)
Previously stated by SilviaS14KA24DE on Club240.com
For OEM stock keyless entry systems 95 < (and above)
1.Get in & lock the doors
2.Insert the key into the ignition 6 times within 15 seconds (taking the key out all the way, then back in).
3.Hazard lights should flash
4.Put key back into the ignition & turn to run position but do not start.
5.Hit the lock button on the remote
6.Hazards should flash.
7.Pull key out and open the drivers door and then close it
8.It should be set
HALT!!!
Remember to do number 7! most people think it's programmed after they pull the key out. you have to unlock the doors, open the drivers door, then close it to be programmed correctly.