Things To Remember When Installing A Transmission

[msaskin]

always make sure the throw-out bearing is properly aligned.

that is all.

my car will be running tomorrow...amen.

~matt

[Mando]

Is that what was causing your slave cylinder problem?

[msaskin]

Originally posted by mandoz85@Oct 3 2004, 09:28 PM
Is that what was causing your slave cylinder problem?
correct.

the TOB was rotated about 90* out of position, so it was at a bit of an angle. Result = release fork not moving back to resting position by itself and requiring too much force (aka; slave cylinder over extending) to compensate.

We pulled the trans this afternoon, immediately saw the problem, fixed it, replaced trans, clutch bled and pumps up perfectly...finally feels like a Spec Stg. 3 should :)

~matt

[Rolan G]

Originally posted by msaskin+Oct 3 2004, 09:31 PM--></div><table border='0' align='center' width='95%' cellpadding='3' cellspacing='1'><tr><td>QUOTE (msaskin @ Oct 3 2004, 09:31 PM)</td></tr><tr><td id='QUOTE'> <!--QuoteBegin-mandoz85@Oct 3 2004, 09:28 PM
Is that what was causing your slave cylinder problem?
correct.

the TOB was rotated about 90* out of position, so it was at a bit of an angle. Result = release fork not moving back to resting position by itself and requiring too much force (aka; slave cylinder over extending) to compensate.

We pulled the trans this afternoon, immediately saw the problem, fixed it, replaced trans, clutch bled and pumps up perfectly...finally feels like a Spec Stg. 3 should :)

~matt [/b][/quote]
OH YA..thanks DOUG and ROLAN, for the help you gave me..hahaha...no problem matt..!!!... thanks for dinner and lunch...

[iser]

LOL!

postwhore #1 = me

[Rolan G]

Originally posted by iser@Oct 4 2004, 01:01 AM
LOL!

postwhore #1 = me
NO jessie...i want to post more.. need to get my numbers up..HAHA

[mr peas]

Originally posted by Rolan G@Oct 4 2004, 01:04 AM
NO jessie...i want to post more.. need to get my numbers up..HAHA
thats the spirit ;)
and good luck with your car matt!
350whp woot!